STERWINS 40VHT2-60.1 Notice De Montage page 222

• USE OF HEARING PROTECTION REDUCES THE ABILITY TO HEAR WARNINGS
FR
(SHOUTS OR ALARMS). THE OPERATOR MUST PAY EXTRA ATTENTION TO WHAT
IS GOING ON IN THE WORK AREA. DO NOT GET DISTRACTED, AND ALWAYS
ES
CONCENTRATE ON THE TASK.
• OPERATING SIMILAR TOOLS NEARBY INCREASES BOTH THE RISK OF
HEARING INJURY AND THE POTENTIAL FOR OTHER PERSONS TO ENTER YOUR
PT
WORK AREA.
• KEEP FIRM FOOTING AND BALANCE.
IT
EL
PL
• TO REDUCE THE RISK OF INJURY ASSOCIATED WITH CONTACTING ROTATING
PARTS, ALWAYS STOP THE MACHINE, REMOVE THE BATTERY PACK, AND MAKE
SURE ALL MOVING PARTS HAVE STOPPED:
RU
- BEFORE CLEANING OR CLEARING A BLOCKAGE
- WHEN LEAVING THE PRODUCT UNATTENDED
KZ
Trimming : Illustration 3.1 to 4.2
NOTE: Try to keep the cutting device angled at approximately 15° to the cutting surface.
1. Cut and remove branches exceeding the cutting capacity of this product using a proper pruner
UA
before operation.
2. Move the cutting device lightly through the cutting surface in a sweeping motion following
the shape of the hedge or shrub.
RO
3. A slight tilt downwards of the cutting device in the direction of motion is recommended for
optimum cutting performance.
4. Do not to rush and do not attempt to cut too much with one stroke of the cutting device.
EN
5. First cut both sides from the bottom cutting upwards to the top. This will prevent any of the
trimmings falling into the path of the area still to be cut .
6. After cutting the sides proceed to the top. Try to keep the cutting device angled at
approximately 15° to the cutting surface.
7. Cut in a number of stages if the area being cut is particularly long to achieve a better result;
smaller trimmings will allow for easy composting.
IF THE PRODUCT IS DROPPED, SUFFERS HEAVY IMPACT OR BEGINS
TO VIBRATE ABNORMALLY, IMMEDIATELY STOP THE PRODUCT AND
INSPECT FOR DAMAGE OR IDENTIFY THE CAUSE OF THE VIBRATION.
ANY DAMAGE SHOULD BE PROPERLY REPAIRED OR REPLACE BY AN
AUTHORIZED SERVICE CENTRE.
NOTE : WHEN SHAPING IT IS ADVISABLE TO ACHIEVE A
TRAPEZOIDAL SHAPE. A TRAPEZOIDAL CUT CORRESPONDS TO THE
NATURAL GROWTH OF PLANTS AND RESULTS IN OPTIMAL HEDGE
GROWTH, AS IT WILL EXPOSE MORE LIGHT TO THE LOWER END OF
THE HEDGE.
• DO NOT OVERREACH. OVERREACHING CAN RESULT IN LOSS OF BALANCE.
ALWAYS BE SURE OF THE FOOTING ON SLOPES.
• WALK, NEVER RUN. KEEP ALL PARTS OF YOUR BODY AWAY FROM ANY
MOVING PART.
• NEVER RUN THE PRODUCT WITHOUT THE PROPER EQUIPMENT ATTACHED.
• DO NOT MODIFY THE PRODUCT IN ANY WAY OR USE PARTS AND
ACCESSORIES THAT ARE NOT RECOMMENDED BY THE MANUFACTURER.
- BEFORE INSTALLING OR REMOVING ATTACHMENTS
- BEFORE CHECKING, MAINTAINING OR WORKING ON THE PRODUCT
- IF THE MACHINE STARTS TO VIBRATE ABNORMALLY (INSPECT
IMMEDIATELY)
222