Technical Design - SATA AB1 Mode D'emploi

Operating Instructions SATA AB 1
EN
The SATA AB1 is supplied fully assembled and ready for operation.
After unpacking
■ Check the SATA AB1 for any signs of damage.
■ Check that the scope of supply is complete.

6. Technical Design

SATA AB1
Electrical control
[4-1]
Pressure regulator valve
[4-2]
Pressure gauge
[4-3]
Adjustable nut
[4-4]
[4-5] Ball valve, demineralised
water supply
Connection, demineralised
[4-6]
water supply
Quick coupling, tank inlet
[4-7]
Container lid
[4-8]
[4-9] Clamp
[4-10] Quick coupling, tank outlet
[4-11] Receptacle
[4-12] Level display
[4-13] Heating sleeve
Bypass circuit
[5-1] Main air valve
Signal lamps
[6-1] Start / Overtemp. ack.
Mains ON
[6-2]
Filter unit
Main body
[7-1]
Thread rod
[7-2]
Colour index threaded rod
[7-3]
fine filter
[7-4] O-ring
Filter cartridge fine filter
[7-5]
Colour index filter cartridge
[7-6]
fine filter
Plastic nut
[7-7]
[7-8] Filter bushing fine filter
[7-9] Display SATA filter timer
40
[4-14] Union elbow
[4-15] Sleeve nut
[4-16] Indicator hose
[4-17] Ball valve, tank bleeder
[4-18] Outlet, tank bleeder
[4-19] Air connection breathing air
pipe
[4-20] Air connection compressed
air supply pipe
[4-21] Electrical connection
[4-22] Main air valve
[4-23] Ball valve bypass
[4-24] Main switch
[4-25] Thermostat
[5-2] Ball valve bypass
[6-3] Heating ON
[7-10] Activation point
[7-11] SATA filter timer fine filter
[7-12] SATA filter timer activated
charcoal filter
[7-13] Activation point
[7-14] Display SATA filter timer
[7-15] Colour index filter cartridge
activated charcoal filter
[7-16] Filter cartridge activated
charcoal filter