König Electronic CMP-WNROUT41 Mode D'emploi page 7

the WPS button on the panel to configure it without manually selecting an encryption method and secret keys.
In the "Wireless settings" menu, click "WPS settings" to enter the next screen.
WPS settings: To enable or disable the WPS function. The default is "disable".
WPS mode: Provides two ways: PBC (Push-Button Configuration) and PIN code.
PBC: Select the PBC or press the WPS button on the front panel of the device for about one second
(Press the button for about one second and the WPS indicator will blink for 2 minutes, which means the
WPS is enabled. While it is blinking, you can enable another device to implement the WPS/PBC
negotiation between them. After two minutes, the WPS indicator will turn off, which means the WPS
connection is completed. If more clients are added, repeat the above steps. At present, the WPS supports
access of up to 32 clients.)
PIN: If this option is enabled, you need to enter a wireless client's PIN code in the field and keep the same
code in the WPS client.
6.5 WDS Settings
The WDS (Wireless Distribution System) is used to expand the wireless coverage area. This Router provides
three modes: Lazy, Bridge and Repeater.
Lazy: In this mode, the connected device can be in Bridge mode or Repeater mode, and enter the Router's
BSSID to establish the connection.
Bridge: You can wirelessly connect two or more wired networks via this mode. In this mode, you need to add
the Wireless MAC address of the connecting device into the Router's AP MAC address table or select one
from the scanning table.
Repeater Mode: In this mode, add the opposing MAC address into each own AP MAC address table
manually or via scanner to enlarge and extend the wireless radio.
Chapter 7: DHCP Server
7.1 DHCP Settings
The DHCP (Dynamic Host Control Protocol) assigns an IP address to the computers on the LAN/private
network. When you enable the DHCP Server, the DHCP Server will automatically allocate an unused IP
address from the IP address pool to the requesting computer on the premise of activating "Obtain an IP
Address Automatically". So specifying the starting and ending address of the IP Address pool is needed.
DHCP Server: Activate the checkbox to enable the DHCP server.
IP Address Start/End: Enter the range of IP address for DHCP server distribution.
Lease Time: The length of the IP address lease.
Chapter 8: Upgrade Firmware
8.1 The Router provides the firmware upgrade by clicking "Upgrade" after browsing the firmware upgrade
packet which you can download from www.nedis.nl
Browse: click this button to select the upgrade file.
Upgrade: click this button to start the upgrading process. After the upgrade is completed, the Router will
reboot automatically.
8.2 Reboot the Router
Rebooting the Router makes the configured settings take effect or sets the Router again if the settings failed.
8.3 Password Change
This section is for setting a new user name and password to better secure your router and network.
User Name: Enter a new user name for the device.
Old Password: Enter the old password.
New Password: Enter a new password.
Re-enter to Confirm: Re-enter to confirm the new password.
7