König Electronic CMP-WNROUT41 Mode D'emploi page 2

Wireless 11N router 300M
Chapter 1: Introduction
1.1 LED Indicator and Port Description
Front Panel and LED Indicator Display
LED indicator description on front panel: (from L to R)
POWER
When the green light stays on, it indicates that the power is connected properly.
SYS
When the green light is blinking, it indicates that the system is running properly.
WPS
When it is blinking, it indicates that the device is negotiating with the client in WPS mode.
WLAN
Wireless signal LED indicator. When the green light is blinking, it indicates that the wireless function is
enabled.
LAN (4, 3, 2, 1)
Wired local network LED indicator. If it stays on, it indicates that it is connected to the Ethernet device;
blinking indicates that the device is transmitting and/or receiving data.
WAN
Wide area network indicator. If it stays on, it indicates the Router's W.
Back Panel Display:
Rear Panel: (From L to R)
POWER
The jack is for power adapter connection. Please use the supplied 9V DC power adapter.
WAN
A 100Mbps Ethernet port that can be connected with MODEM, Switch, Router and other Ethernet devices for
Internet connection to DSL MODEM, Cable MODEM and ISP.
LAN (1, 2, 3, 4)
4 10/100Mbps Ethernet ports can be connected with Ethernet switch, Ethernet router and NIC card.
RESET
The system reset button. Press this button for 7 seconds, the settings configured in this device will be deleted
and it will restore the default settings.
WPS
Press it for 1 second, the WPS feature will be enabled and the WPS indicator will blink.
ENGLISH
2