Makita DKT360 Manuel D'instruction page 6

Power supply stand
10
11
12
Fig.2
10 Carrying handle
12 Power switch
14 Temperature sensor
FUNCTIONAL DESCRIPTION
Always be sure that the appliance is
CAUTION:
switched off and the battery cartridge is removed before
adjusting or checking function on the appliance.
Installing or removing battery cartridge
Always switch off the appliance
CAUTION:
before installing or removing of the battery cartridge.
Hold the appliance and the battery car-
CAUTION:
tridge firmly when installing or removing battery cartridge.
Failure to hold the appliance and the battery cartridge firmly
may cause them to slip off your hands and result in damage to
the appliance and battery cartridge and a personal injury.
To remove the battery cartridge, slide it from the appli-
ance while sliding the button on the front of the cartridge.
To install the battery cartridge, align the tongue on the battery
cartridge with the groove in the housing and slip it into place.
Insert it all the way until it locks in place with a little click.
1
2
Fig.3
► 1. Button 2. Battery cartridge
13
14
15
11 Power supply
connector
13 Battery cartridge
15 Ground sensing
element
Always install the battery cartridge
CAUTION:
fully. If not, it may accidentally fall out of the appli-
ance, causing injury to you or someone around you.
Do not install the battery cartridge
CAUTION:
forcibly. If the cartridge does not slide in easily, it is
not being inserted correctly.
NOTE: The appliance does not work with only one
battery cartridge.
Indicating the remaining battery
capacity
Fig.4
► 1. Battery indicator 2. Check button
Press the check button to indicate the remaining battery
capacities. The battery indicators correspond to each
battery.
Battery indicator status
On
6 ENGLISH
2
1
Off
Blinking
Remaining
battery
capacity
50% to 100%
20% to 50%
0% to 20%
Charge the
battery