Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
To actuate the state of charge, press the state of charge
button. A combination of the four LEDs will illuminate
designating the level of charge left. When the level of
charge in the battery is below the usable limit, the state of
charge Indicator LEDs will either not light or the bottom
LED will blink.
nOTE: The LED state of charge will only display once the
state of charge button is pressed.
Fig. D
•
Press state of charge button at anytime to display the
remaining level of charge.
nOTE: The state of charge is only an indication of the
charge left on the battery. It does not indicate tool
functionality and is subject to variation based on product
components, temperature and end-user application.
nOTE: GoPak battery terminal cap should be used when
battery is not connected to a power tool. Terminal cap is
provided for use whenever the battery is out of the tool.
Remove cap before placing battery into tool.
SAVE THESE INSTRUCTIONS FOR
FUTURE USE
COMPONENTS (FIG. A)
WARNING: Never modify the power tool or any part
of it. Damage or personal injury could result.
Refer to Figure A at the beginning of this manual for a
complete list of components.
Intended Use
Your BLACK+DECKER LED light has been designed
for lighting applications. This product is intended for
household, consumer use only.
DO nOT use under wet conditions or in presence of
flammable liquids or gases.
DO nOT let children come into contact with the tool. Supervision
is required when inexperienced operators use this tool.
96-100% charged
76-95%
51-75%
26-50%
Pack needs to be charged
9
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
GoPak Tool Terminal Cap (Fig. E)
A battery storage and carrying cap
whenever the battery is out of the tool. Remove the cap as
shown in Figure E before placing battery onto tool.
Fig. E
OPERATION
WARNING: To reduce the risk of serious personal
injury, turn unit off and remove the battery pack
before making any adjustments or removing/
installing attachments or accessories. An
accidental start-up can cause injury.
Installing and Removing the GoPak 2 in 1
Battery in a Power Tool (Fig. F)
WARNING: Remove any connected USB cords from
the BLACK+DECKER GoPak 2 in 1 battery before
connecting the GoPak to the compatible tool.
1. Remove the tool terminal cap if installed on the
BLACK+DECKER GoPak 2 in 1 battery.
2. To power a compatible GoPak 12V MAX* power tool,
align the tool terminals on the foot of the tool with the
terminal slots on the battery
nOTE: The state of charge indicator will face the rear of
the tool and the USB ports will face the front. The arrow on
the battery will align with the arrow on the tool as shown
in Fig. F.
3. Snap the BLACK+DECKER GoPak 2 in 1 battery into the
foot of the tool. The arrow
with the arrow
12
on the tool. Ensure the battery is
fully seated and fully latched into position before using.
4. To remove the BLACK+DECKER GoPak 2 in 1 battery
from the tool, depress the two battery release buttons
located on the tool and pull the BLACK+DECKER
5
GoPak 2 in 1 battery off the tool.
nOTE: The BLACK+DECKER GoPak 2 in 1 battery USB ports
are disabled when the trigger is pulled.
English
is provided for use
10
10
4
as shown in Fig. F.
13
on the battery will align
5
Publicité
Table des Matières
