vita MultiPump Mode D'emploi page 20

VITA MultiPump
Pos Action
9 Attach the pins provided on the underside of the
VITA MultiPump housing.
10 Now use the pins to hang the VITA MultiPump
into the mounting holes provided for this purpose
on the attached bracket.
11 Using a sharp knife or similar, cut a section
approximately 25 cm in length off the vacuum
tube provided. Ensure that you cut the tube off as
vertically as possible.
Now connect the VITA vacuum pump to the
VITA MultiPump using the cut section of vacuum
tube.
While applying a little pressure to the
connection, insert the vacuum tube until it slips
into the quick coupling with a "jerk".
20
E
Picture