Service And Warranty - Lifegoods LG1102 Manuel D'utilisation

Cleaning the Side Brush
Remove the brush. Clean the brush stand and reinstall the brush.
-
Cleaning the Cliff Sensors and Charging Contacts
Wipe the robot's cliff sensors with a clean and dry cloth. Wipe the charging contacts on the robot and
-
the charging base with a clean and dry cloth.
Cleaning the Floor Tracking Sensor
Use a clean and dry microfiber or soft cotton cloth to wipe any debris that has accumulated in the round
-
sensor opening on the right side of the bottom surface. Do not spray cleaning solution directly into the
sensor entrance.
Cleaning the Rolling Brush
Pull on the release tabs to unlock the brush guard. Lift the rolling brush to remove it. Clean the rolling
-
brush with the cleaning brush or with a vacuum cleaner. Reinstall the rolling brush by inserting the fixed
protruding end first and then clicking it into place. Press the brush guard down until it clicks into place.
Troubleshooting
The front driving
One beep
The side brush is
Two beeps
The power button
stays red
Three beeps
Four beeps
Two beeps
- The cliff sensors
Three beeps
The power button
flashes red
on a dark surface
Four beeps
return to its char-
26
Clean the front driving wheel and press
wheel is stuck. the power button to restart the robot.
Clean the side brush and press the
stuck. power button to restart the robot.
- Remove and empty the robot's dust
The vacuum fan bin.
- Empty the filter.
is stuck, or the
filter is clogged.
- Make sure the vacuum inlet is not
blocked by any hair or debris.
Remove and clean the main rolling
The main rolling
brush and brush guard. Press the power
brush is stuck.
button to restart the robot.
- Tap the bumper to dislodge any debris
The bumper is that might be trapped underneath.
stuck. - Press the bumper 5-10 times to ensure
that the bumper contracts freely.
- Clean the cliff sensors with a dry cloth.
are dirty - Start cleaning in a new location if the
- The robot is robot is hanging over a drop or is stuck
hanging over a on a dark surface.
drop or is stuck - Use the boundary strip or a physical
barrier to block off the problem area.
- Battery power - Manually take the robot to its charging
is too low. dock to charge.
- Robot cannot - Ensure that there are no obstacles in
front of the charging dock. Wipe the
ging dock. contacts on both the robot and char-
ging dock clean with a clean, dry cloth.
Storage
Always let the Robot Vacuum Cleaner charge on the charging dock when you are not using it. Place the
-
Robot Vacuum Cleaner and charging dock in a clean and dry place. Do not store the device in extreme
high or extreme low temperatures.
Disposal - Recycle
Contribute to a cleaner living environment! Do not dispose of the Robot Vacuum Cleaner with the
-
household waste. For proper recycling, please contact your local authority or your household waste
disposal service for further details on your nearest designated collection point.

Service and Warranty

If you need service or information regarding your product, please contact the LifeGoods Customer
-
Support at service@lifegoods.nl
LifeGoods provides a 2 year warranty on its products. To obtain service during the warranty period, the
-
product needs to be returned with a proof of purchase. Product defects have to be reported within 2
years from the date of purchase. This warranty does not cover: damages caused by misuse or incorrect
repair; parts subject to wear; defects that the customer was aware of at the time of purchase; damages
or defects caused by customer neglect; damages or defects caused by third parties.
Disclaimer
Changes reserved; specifications are subject to change without stating grounds for doing so.
-
27