Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Function
Controls
Remote Control
Spot Cleaning
App
Function
Controls
Remote Control
Changing the
Cleaning Suction
App
Function
Controls
Remote Control
Edge Cleaning
App
22
Explanation
Intensely cleaning a localized area by spiraling 1 meter
outward in diameter and then spiraling inward to where it
started. When spot cleaning, the robot boosts its vacuum
power to provide the best cleaning possible.
Place the robot on top of the spot that you want to clean
and press on the remote control.
Explanation
Press on the remote control or app to adjust the suction
up to 2000Pa. Vacuum cleaning suction is 800Pa by
default.
Explanation
After cleaning the open areas of your floor, the robot
will use Edge Clean to clean along the walls and around
furniture legs. Press on the remote control if you prefer a
quicker edge cleaning.
Function
Controls
Remote Control
Single Room
Cleaning
App
Function
Controls
Remote Control &
App
Manual Cleaning
Using the Boundary Strips
Keep the Robot Vacuum Cleaner Away from areas you don't want it to clean. The vacuum cleaner will
-
recognize the boundary strip and will not cross it.
Measure the size of the area you want to close off for the Robot Vacuum cleaner. If necessary, you can
1.
cut the strip to a shorter length.
Place the adhesive strip flat on the floor.
2.
If the Boundary Strip rolls up, re-apply it on the floor with some adhesive tape. A rolled up Boundary
-
Strip does not work well.
Keep the Boundary Strip away from objects that emit excessive heat.
-
Explanation
Intensively cleaning a single room. The robot stops after
30 minutes. Select this mode if only one specific room
needs to be cleaned. Make sure to close the door.
Explanation
Cleaning a particular area.
Use the directional buttons on the remote control.
23
Publicité
Table des Matières
