Pattfield Ergo Tools E-ES 430 E Instructions De Service page 7

Anleitung E-ES 430_SPK7:_
Select the speed by pressing the switch (4) to a
greater or lesser extent. To pre-select the speed turn
the knurled screw (7) of the switch (4).
The machine can be operated either
intermittently or continuously
6.2 Working with the eccentric sander
The entire sanding surface must rest on the
workpiece.
Switch on the machine and, applying moderate
pressure, move it over the workpiece in circular,
crosswise or lengthwise movements.
Use a coarse-grained disk for rough sanding and
a fine-grained disk for fine sanding. The best
grain for a particular job is best ascertained by
trial runs.
7. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before
starting any cleaning work.
Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
Maintenance
There are no parts inside the equipment which
require additional maintenance.
Ordering replacement parts
Please quote the following data when ordering
replacement parts:
Type of machine
Article number of the machine
Identification number of the machine
Replacement part number of the part required
02.07.2007 9:08 Uhr Seite 7
For our latest prices and information please go to
www.isc-gmbh.info
8. Disposal and recycling
The unit is supplied in packaging to prevent its being
damaged in transit. This packaging is raw material
and can therefore be reused or can be returned to
the raw material system.
The unit and its accessories are made of various
types of material, such as metal and plastic.
Defective components must be disposed of as
special waste. Ask your dealer or your local council.
GB
7