Components; Assembly Instructions; Folding The Highchair - tuc tuc AUPA Mode D'emploi

COMPONENTS

6
+
MONTHS
5 Height positions
1
Easy-wash material
2
100% cotton insert cushion
3
3 Reclining positions 150º
4
5 Extra large double tray, removable
with one hand
10
cushion cover
100% cotton insert cushion
belts
tray
chair
fasteners
screws to hold the axis
side legs
basket
footrest
wheels
feet protectors
3 Footrest positions
6
Back wheels
7
Harness with 5 fastening points
8
Basket to hold objects
9
10 Leg folding mechanism

ASSEMBLY INSTRUCTIONS

1. Chassis Assembly (1)
1.A. Remove the structure of the highchair from
the box.
1.B. Press the side buttons on the right leg and
slide them open Repeat this with the left leg. (2)
1.C. Position the front and back tube into the
front and back bases, using the screws as shown
in figure (3).
2. Chair Assembly
2.A. Position the seat in the support located at
the top of the chassis. (ensure that the grooves of
the seat fit into the spaces designed for them).
2.B. Secure the seat into the round axis and
fasten it with the plastic side fasteners. (4)
3. Footrest Assembly.
3.A. To install the footrest, start from the left.
Insert the piece into its groove, until it is fully in
place. (5)
4. Installing and using the tray (6)
4.A. To remove the double tray, take hold of the
sides and pull upwards.
4.B. The tray has three possible positions.
4.C. The tray can be removed and placed in the
back section of the legs of the highchair as shown
in the image. (7)
4.D. Put the basket in the bottom of the
(8)
highchair.
5. Reclining the highchair (9)
5.A. Pull the lever of the reclining system and
find the position that is best suited to each use,
free the mechanism to place the backrest in the
desired position.
5.B. The back can be adjusted while your baby is
seated.
6. Adjusting the height of the seat (5 positions)
(10)
6.A. Stand in front of the highchair, press the two
red buttons, located below the seat, at the same
time and lift and lower the seat into the desired
position. Free the mechanism in order to set the
desired height.
6.B. To adjust the seat into the highest position
with one hand, hold the structure of the
highchair in place and use your other hand to
lift the seat. This can be done while the child is
seated in the highchair.

7. Folding the highchair

7.A. Unfasten the safety belts and remove the
child from the highchair.
7.B. Remove the tray from the highchair and
position in the back section of the legs.
7.C. Stand behind the highchair and place the
highchair at the lowest height. Press the side
buttons located higher up and pull towards you.
You will hear the highchair's locking system. (11)
& (12)
11