Installation And Connection; Operation - Bartscher 135105 Mode D'emploi

5.2 Installation and connection

•
Discard the complete packing material after unpacking the device.
•
Place the device on top of an even and safe surface which supports the weight of
the device and is dry.
•
Not at any time should you place the device on an inflammable surface.
•
You must not position the device near open fireplaces, electric ovens/arc furnaces,
furnaces/electric heaters or other heat sources.
•
The electrical circuit in the socket must be secured to at least 16A. Only connect the
device directly to the wall socket; do not use any extension cords or power strips.
•
Place the device so that the plug is easily accessible and can be quickly removed
from its socket in case of necessity.

5.3 Operation

Disinfection and cleaning before use
•
Clean and disinfect thoroughly all parts of the device that come into contact with food
(blender jar, mixing rod, mixing disks) before first use. Fill the jar to about 3/4 of its
capacity with a solution of commercially available disinfectant and water (ratio: 1
tablespoon (15 ml) of disinfectant for 3.8 liters of clean, cold (ca. 16 ° C) water).
•
Put the blender jar in the device and let the device run at speed "l" (slow) for
about 1 minute. Then switch off the device. Follow the instructions contained in
the "Start-up" section.
•
Remove the jar from the device and empty it. Rinse the blender jar with fresh water.
•
In order to remove the moisture from the mixing rod and mixing disks, attach the empty
blender jar to the holder and let the device run at speed "I" (slow) for about 30
seconds. Do not rinse the blender jar after disinfection.
•
Clean the housing of the device with a soft, damp cloth.
Start-up
•
Insert the unit's plug to a single grounded outlet.
•
Ensure the switch is located in the „O" position.
•
Fill the shaker with the desired ingredients.
CAUTION!
While filling the shaker, ensure that the maximum filling volume is not exceeded
(higher mark, approx. 650 ml).
The shaker must not be underfilled, as the mixing tip may not reach the
ingredients. Ensure that the ingredients in the shaker reach the minimum filling
volume mark (approx. 200 ml!)
- 21 -