Warranty And Service - Tenovis HSG-BASISMODUL DECT Notice D'utilisation

WARNING: The following master reset and overides should only be invoked if you have
failed to achieve satisfactory product performance having followed the troubleshooting
hints and tips provided in the Troubleshooting Section (see page 26). It is strongly advised
you contact your next Tenovis supplier before attempting these functions.
MASTER RESET
This reset will cause all HSG-Basismodul DECT settings to revert to their original factory default
values. To perform a reset:
1. Press and hold the Page Button (8), then press the Headset Button (2) and Mode Button (5) and
hold all three buttons until all the base unit indicator lights start blinking. This will take
approximately 3 seconds.
2. The reset is then complete, the factory default settings reinstated and the HSG-Basismodul
DECT will revert to it's normal power-up state. Wait 5 seconds before operating the HSG-
Basismodul DECT. If this operation is performed in Headset mode during a call you may
lose the call.
TRANSMIT OVERRIDE
1. Ensure the system is in Headset mode.
2. Press and hold the Page Button (8), press the Mode Button (5), then release both buttons.
The Speak Indicator (6) blinks.
3. Press the Up (3) or Down (4) button to adjust the Speak Volume range.
4. Press the Mode button (5) or wait 10 seconds to save the new seting and exit.
RECEIVE OVERRIDE
1. Ensure the system is in Headset mode.
2. Press and hold the Page Button (8), press the Mode Button (5) twice, then release both buttons.
The Tone Indicator (7) blinks.
3. Press the Up (3) or Down (4) button to adjust the receive level.
4. Press the Mode Button (5) or wait 10 seconds to save the new setting and exit.

WARRANTY AND SERVICE

• Tenovis guarantees the satisfactory condition of the equipment with regard to manufacturing
and material defects for 2 years from the date of purchase. (Please retain the original receipt).
• This product should be installed and used in accordance with the instructions detailed in this
user guide, and serviced at an approved Service Centre. Failure to comply with these conditions
may render the warranty void.
• This does not affect your statutory rights.
OVERRIDE FUNCTIONS
UK
30