Basic Settings - Tenovis HSG-BASISMODUL DECT Notice D'utilisation

UK
PLACING AND RECEIVING A CALL USING THE HANDSET
a) HSG-Basismodul DECT on AEI interface
The telephone handset can be used as normal
b) HSG-Basismodul DECT on Handset interface (telephones without AEI interface)
Ensure you are in handset mode. If necessary press the Headset/Handset button (2) to select
Handset mode - the Headset Indicator (1) will be extinguished when in Handset mode. Take the
handset off the hook and dial in the normal way. When the call is complete, return the telephone
handset to the cradle to disconnect and end the call. The HSG-Basismodul DECT will remain in
Handset mode until the Headset/Handset or Talk button is pressed again.
In Handset mode the telephone can be used to make and receive calls in the normal way.

BASIC SETTINGS

Before adjusting Listen Volume, Speak Volume, Listen Tone and Audible Cue Volume, ensure the
system is in Headset Mode.
When setting Listen Volume, Speak Volume and Listen Tone, you will hear a beep through the
headset each time you press these buttons. A double beep indicates you have reached the upper
or lower limit and a triple beep indicates that the mid-range setting has been reached.
LISTEN VOLUME – HOW OTHERS SOUND TO YOU
The Listen Volume can be adjusted by pressing the Volume Up (17) or Volume Down (18) button
on the remote pack to increase or decrease volume to a comfortable level. Alternatively you can
use the Up (3) or Down (4) button on the base unit, which provides the same function.
SPEAK VOLUME – HOW YOU SOUND TO OTHERS
Press the Mode Button (5) once to select Speak Volume Adjust. The Speak Volume Indicator (6) will
illuminate, and you will hear a triple beep in your headset. Adjust the volume level using the
Volume Up (17) or Volume Down (18) button. Once you are satisfied with the setting press the
Mode Button (5) once to select Listen Tone, twice to return to default or simply wait 10 seconds for
the new setting to be saved. The base unit Up (3) and Down (4) buttons will then revert to their
default function of listen volume adjust.
This control can only adjust the speak volume for the headset and cannot adjust the speak volume
for the telephone handset.
Tip: Normally the speak volume adjustment need only be made once when initially setting
up the HSG-Basismodul DECT and should not require adjustment thereafter. Too high a
speak volume level can cause audio problems so be careful to set this at a comfortable
level for the person at the other end. Refer to the Troubleshooting Guide page 26 for
more information.
21