Kebo Fleem Valencia Bio-Ethanol 2.0 Mode D'emploi page 21

Please ensure (prior to installation), that the installation materials enclosed are suitable for the job!
It is important to attach the fireplace to the wall before using it!
When you unpack the fire, you will find two long wall mounting brackets and two safety clamps. Only mount
the appliance on walls that are made of the following fire proof materials: concrete, brick, hollow building
stone and building blocks or plasterboard. The packaging contains Fischer plugs and screws for mounting
the unit on the wall. Only use these plugs or ask an expert for advice if in doubt. Use a suitable 8 mm drill to
drill 60 mm deep holes.
1. Fix the mounting bracket and the 2 safety clamps onto the backside of the outer metal box with the
Φ4x8 screws.
2. Fix the Bracket into wall with 4 rawl plugs and the Φ8x25 screws and then hang the fire on.
Fix the safety clamps with 2 rawl plugs and the Φ8x25 screws at last.
3.
Mount the 'Fleem® Valencia Bio-Ethanol 2.0' level on a stable, fully fire-proof foundation which
is suitable for this fixation method. Connect the Electra power supply to a suitable grounded
outlet (230 V 50 hz 1ph).
4. Install the fire surround it onto the fire.
5. Installation is complete.
Attention!
Only mount the appliance on walls that are made of the following fire proof materials: concrete, brick,
hollow building stone and building blocks or plasterboard. The packaging contains Fischer plugs and
screws for mounting the unit on the wall. Only use these plugs or ask an expert for advice if in doubt.
Use a suitable 8 mm drill to drill 60 mm deep holes.
21