Pattfield PE-1200 TS Traduction De La Notice Originale page 89

CUTTING DEPTH
1 Open the depth clamping
push in to set the desired cutting depth.
Lower indicator = without guide rail
Upper indicator = with guide rail
BEVEL CUTS
1 Open the angle clamping knobs 15.
Lower indicator = 0° bevel angle
Upper indicator = 45° bevel angle
SAW BLADE REPLACEMENT
1 Open fast fix lever 6, push the lock off
button 5 and lower the saw blade until
it clicks in place.
Caution! Make sure the tool is
switched off and unplugged. Set
max. cutting depth and wear protective
gloves.
3 Place a new saw blade in the tool.
Caution! Observe that the rotation
direction of the saw blade corre-
sponds with the tool.
GUIDE RAIL (ACCESSORY)
1 The guide rail can be purchased at your
local Hornbach store.
Part no: 5661036
Place the guide rail on the workpiece
as desired.
knob 10 and 2 Tighten the depth clamping knob
securely.
2 Set the desired angle and tighten the
angle clamping
2 Loosen the saw blade clamp washer
with the hex key
saw blade 2.
4 Tighten the saw blade clamp washer
with the hex
fix lever 6.
Caution! The tool can rebound
when fast fix lever is closed.
2 Put the tool on the guide rail and adjust
the play adjustment
ingly. Close the anti-rebound knob
afterwards.
Run the tool along the guide rail while
sawing.
10
knobs 15 securely.
17 and remove the
key 17 and close the fast
screws 4 accord-
11
EN 87