Kenwood KAC-X20 Mode D'emploi page 4

Connection
2WARNING
To prevent fire caused by a short in the wiring,
connect a fusible link or breaker nearby the
battery's positive terminal.
2CAUTION
• If sound is not output normally, immediately
turn power off and check connections.
• Be sure to turn the power off before changing
the setting of any switch.
• If the fuse blows, check wires for shorts, then
replace the fuse with one of the same rating.
• Check that no unconnected wires or
connectors are touching the car body. Do
not remove caps from unconnected wires or
connectors to prevent short circuits.
• Connect the speaker wires to appropriate
speaker connectors separately. Sharing the
negative wire of the speaker or grounding
speaker wires to the metal body of the car can
cause this unit to fail.
• After installation, check that the brake lamps,
winkers, and wipers work properly.
NOTE
• Do not connect cables and leads to both RCA
cable input jacks and the speaker level input
terminals simultaneously, for this may cause
malfunction or damage.
* Commercially available parts
■ Remote cable connection (Optional accessory)
2CAUTION
• Before connecting the remote controller
cables, always turn the Bass boost level knob
all the way to the left.
4 English
CENTER UNIT
(CD receiver, etc.)
FUSE(30A 2)
POWER IN
Terminal cover
Battery wire*
Protective Fuse*
Ground wire*
Battery
FUSE(30A 2) POWER IN
RCA cable*
Power control wire
■ Bridged Connections
Remote cable (6.0 m : 19.7 ft)
Left input
Right input
Lead terminal*
Right speaker
Left speaker
Speaker (Bridged)
Remote controller