Samsung DV50K7500E Série Mode D'emploi page 25

Using the short hose as an extension
DV7500K-03381C-02_EN.indd 25
B
A
C
1. Close the cold water tap. If you have
a washer cold water hose attached to
the cold water faucet, unscrew and
remove the hose. Then, connect the
short hose (B) to the cold water tap.
Turn the coupling by hand until it is
tight.
Using pliers, tighten the coupling an
2.
additional two-thirds turn. Do not
overtighten. You can damage the
coupling.
3. Connect the Y connector (A) to the
brass male end of the short hose. Turn
the coupling by hand until it is tight.
4. Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten. You can damage the
coupling.
5. Connect the angled end of the water
hoses (C) to the filling valve at the
bottom rear of the dryer. Turn the
coupling by hand until it is tight.
6. Using pliers, tighten the coupling an
additional two-thirds turn. Do not
overtighten. You can damage the
coupling.
7. If you detached the cold water hose
from your washer, attach the hose
to the free end of the Y connector,
tighten the coupling by hand until it is
tight, and then, using a pliers, tighten
an additional two-thirds turn.
8. Open the cold water tap, and then
check for any leaks.
English 25
4/7/2016 5:05:46 PM