König Electronic CMP-WNUSB40 Mode D'emploi page 5

Wi-Fi Protect Setup (WPS)
If you have WPS-enabled wireless access point, and you want to establish a secure connection to it, you don't have to
configure the wireless access point and setup data encryption by yourself. All you have to do is to go to the WPS setup
page of this wireless card, click the PBC or PIN button, and then press a WPS button or enter a set of 8-digit code on the
wireless access point you wish to establish a secure connection.
Pin Input Config (PIN)
1. The PIN code of your wireless network card is an eight-digit number located at the upper-right position of configuration
utility. Remember it, and input the number to your wireless access point as the WPS PIN code (Please refer to the
user manual of your wireless access point for instructions about how to do this)
2. Click 'Pin Input Config (PIN)' button now, and the following message will appear on your computer, click 'Yes' to select
a specific wireless access point or click 'No' to start PIN method of WPS .
3. If you click 'Yes', and a message will appear on your computer, please select the SSID of wireless access point that
you wish to connect and click 'Select'.
4. Please wait while the install procedure is running and wait for few seconds to two minutes. If a wireless access point
with correct PIN code is found, you'll be connected to that access point.
Push Button Config (PBC)
1. Start PBC pairing procedure at access point side (please refer to the instruction given by your access point's
manufacturer), then click 'PBC' button in wireless configuration utility to start to establish wireless connection by WPS.
Please be patient (This may require several seconds to one minute to complete).
5