Silverline 869235 Mode D'emploi page 8

GB
Troubleshooting
Problem
Pump is running, but does not
deliver water
Pump does not start or suddenly
stops during operation
Pump runs, but output suddenly
decreases or ceases
If the above troubleshooting solutions fail, contact your dealer or an authorised Silverline service centre.
8
Possible cause
Output hose kinked or clogged
Impeller clogged
Impeller damaged
Water level falls below the minimum when pump
starts
Motor overheated; thermal overload protection has
switched off
No power
Dirt particles are jammed in the suction base
Suction base is clogged
Solution
Ensure hose is clean and not kinked
Clean impeller (see 'Maintenance')
Contact your dealer or an authorised Silverline service centre
Submerge pump deeper
Disconnect from power supply and investigate the cause; clean impeller
(see 'Maintenance'); observe max. temperature of 35°C
Check fuses and electric connections; consult qualified electrician if
necessary
Clean suction base
Clean suction base