Water Installation - SMIXIN COMPACT Guide D'installation

1. Open the Black Box (2) by unscrewing the 4 screws of the
cover using a 6,5 x 1,2 mm slotted screwdriver.
2. Unscrew the pressure dome from the cable gland M32.
3. Pass the cable sleeve (1) on the cable gland and push it
into the Black Box. Clip the cubic ferrite around the 2
cables (4).
4. Connect the USB male cable on the embedded computer
of the Black Box, clip the other ferrite around USB cable
(3). If this ferrite is misplaced, use the key to open it.
5. Connect the male power connector from the cable sleeve
to the female connector power of the embedded
computer.
6. Screw the 2 wires to the terminal bloc.
7. Connect the female power supply connector from the
cable sleeve to the male connector of the power supply.
8. Close the Black Box by screwing the 4 screws .

6.2 Water installation

(illustration D + H)
CAUTION
• Before proceeding to the installation,
check the condition of water tube.
• Do not connect the power supply
during these steps.
1. Determine the installation area of the Black Box (2) to
adjust the length of the flexible water connector.
SMIXIN SA | Rue Centrale 115 | CH-2503 Bienne
T : +41 32 366 64 00 | info@smixin.com
V2 09/2017
Page | 15