SMIXIN COMPACT Guide D'installation page 14

CAUTION:
• Be careful not to damage anything
when unpacking the components.
• Be careful with the cable sleeve and
never pull on it!
• Surfaces must be dry
1. Screw the threaded bar from the Tap fixation kit (7) onto
the Compact Tap module (1).
2. Position and center the Compact on the sink. Do not forget
to pass the water tube and cable sleeve through the hole
of the work surface.
3. Slide the rubber horseshoe from the Tap fixation kit
followed by the metal horseshoe on the inferior part of the
threaded bar. Make sure to first place the rubber
horseshoe in contact with the sink.
4. Screw the nut from the Tap onto the threaded bar with the
13-mm wrench. It must be tightly secured so the Compact
holds in place on the work surface.
6 Installation of the Black Box
6.1 Installation of the electronics
(illustration C)
CAUTION
• Use caution when plugging connector.
SMIXIN SA | Rue Centrale 115 | CH-2503 Bienne
T : +41 32 366 64 00 | info@smixin.com
V2 09/2017
Page | 14