Bosch EasyComfort I 6 TDS60 Série Notice D'utilisation page 21

Problem
Water flows
through the holes
on the soleplate.
Dirt comes out
through the
soleplate.
The "Calc'nClean"
indicator light (2)
does not turn off.
The appliance
makes a pumping
sound.
Loss of pressure
during ironing.
Water spots
appear on the
garment during
ironing.
The hose gets hot
during use.
Water leakage
from the boiler.
If the above tips do not solve the problem, get in touch with
our customer service.
You can download this manual from the Bosch local
homepages.
* Model dependent
Possible causes
1. The water is condensing
inside the tubes because
steam is being used for the
first time or has not been
used for a long time.
1. There is a build up of
limescale or minerals in the
boiler and iron.
2. Chemical products or
additives have been used.
1. The iron descaling process
has been stopped before
being completed.
1. Water is being pumped into
the steam tank.
2. The sound does not stop.
1. The steam release button
has been activated for too
long a period of time,
meaning it has been pressed
too frequently.
1. May be caused by steam
condensed on the ironing
board.
1. This is normal. It is caused
by the steam passing
through the hose during
steam ironing.
1. Boiler cap (8) is loose.
Solution
1. Point the iron away from the
ironing area and press the
steam release button until
steam is produced.
1. Carry out a cleaning cycle
(see the "Descaling process"
section).
2. Never add products to the
water (see the "Filling the
water tank" section).
Clean the soleplate with a
damp cloth.
1. Restart and complete the iron
descaling process.
1. This is normal.
2. If the sound does not stop, do
not use the steam station and
contact an authorised
technical service centre.
1. Use the steam release button
at intervals.
1. Wipe the textile cover of the
ironing board, and iron any
water drops to dry them.
1. Place the hose on the
opposite side so that you do
not touch the hose during
ironing.
1. Tighten the cap.
21
BOS CH