ProfiCare PC-MD 3026 A Mode D'emploi page 33

Initial Operation
1. Remove the oral irrigator from the charging station.
2. Attach a nozzle. Turn the nozzle so that the opening
faces the front of the appliance.
3. Open the water tank cover on the back side of the
appliance.
4. Fill the water tank with lukewarm water and close the
water tank cover again. Make sure the sealing ring is
fitted properly.
5. Select the "Normal" setting using the MODE button.
6. Turn on the appliance using the ON / OFF button.
7. Allow all water in the water tank to flow through the
nozzle in order to remove any residue.
8. Turn off the appliance.
9. Briefly rinse off the nozzles under running water.
Your oral irrigator is now ready for use.
Usage
Before using the water jet you should clean your teeth with
a toothbrush.
1. Open the water tank cover on the back side of the
appliance.
2. Fill the water tank with lukewarm water and close the
water tank cover again.
WARNING:
Do not fill it with hot water!
WARNING:
• Turn the appliance off. Remove the charging station plug from
the socket when you clean the appliance.
• Do not submerge the appliance and the charging station in water.
It could result in an electric shock or fire.
CAUTION:
• Do not use any wire brush or other abrasive objects.
• Do not use any sharp or abrasive cleaners.
1. Draw the water tank downwards.
2. If necessary, pour the remaining water out.
3. Clean the suction hose with a soft cloth.
4. Remove the filter and clean it carefully using warm
running water.
5. Rinse out the water tank.
6. Insert the filter in the hose once again.
7. Guide the hose into the upper opening of the water tank.
PC-MD 3026 A_IM
3. In order to clean the nozzles, allow water to flow through
the nozzle head (at maximum water pressure) into the
wash basin before and after each time the appliance is
used.
NOTE:
Do not hold the appliance at a too much slanting
angle otherwise no water will be able to spray from the
appliance.
4. Next, use the MODE button to select the desired setting
"Normal", "Soft", "Pulse").
5. Lean over the wash basin. Guide the water jet along the
gums, around the teeth. Hold the appliance upright as
far as possible. Clean all four parts of your mouth in this
way. Keep your mouth slightly open so the water can
leak out.
WARNING:
Do not hold the nozzle too close to your gums or your
teeth.
6. If the water becomes used up before you are finished
with the cleaning, turn off the appliance using the
ON / OFF button. Add more water.
7. To stop operation, turn the appliance off.
NOTE:
For security, the appliance automatically turns off after
2 minutes.
8. Please clean the appliance as described under
"Cleaning".
Cleaning
8. Place the water tank in the appliance once again. Pay
attention to the guides and make sure the sealing ring
is fitted properly. The water tank must snap into place
audibly.
9. Press the release button and remove the nozzle. Clean
the nozzles under warm running water. Dry off the
nozzles.
10. Clean the appliance and the charging station with a
damp cloth. Finally, wipe the parts until they are dry.
33
09.03.18