Olympia PS 407.2 CCD Mode D'emploi page 25

11 Troubleshooting
Problem
Device does not
work
Device
continues to run
after shredding
Device no
longer functions
after a longer
period out of
service or stops
during operation
Overloading
(material jam)
If you cannot clear the fault yourself, contact your dealer or call the Olym-
Note:
pia hotline.
Diagnosis & Cause
Is the power plug connected
properly in the power socket?
Is the On/Off switch set to
OFF?
Has the device been assembled
properly?
Does the motor fail to start
when paper is inserted?
Internal sensor is covered by
residual paper or is soiled.
Was the device shutdown for a
longer time? Is the surface of
the device warm? The
permissible operating cycle has
probably been exceeded.
Have you exceeded the
permissible material
(refer to Chapter "Technical
Data")? Has the material been
fed in askew?
Solution
Connect the power plug to the
power socket properly.
Set the On/Off switch to its ON
position.
Ensure that the waste bin has
been inserted properly.
Slide the material to be
shredded in the respective
infeed slot so that it makes
contact with the sensor in the
middle.
Press the REV button so that
the cutting mechanism runs in
reverse and feeds the material
back out of the shredder to free
the blocked infeed.
First of all, disconnect the
power plug from the power
socket and allow the motor to
cool down to room temperature.
For information on the operating
cycle, refer to Chapter
"Technical Data".
Clear the material jam, refer to
Chapter "Clearing a material
jam".
25