Maintenance And Cleaning - Kerbl SH30 Mode D'emploi

Masquer les pouces Voir aussi pour SH30:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 13
Setting the water fill level height
1. Remove the valve cover
2. Loosen the wing nut on the float arm of the valve
3. Set the height of the float
4. Re-tighten the wing nut on the float arm of the valve
5. Re-attach the valve cover

Maintenance and cleaning

CAUTION!
Risk of physical injury to people and animals and property damage
• Only perform maintenance and cleaning work with the electrical system switched off.
• If the drinking bowl is not used for some time, always drain the residual water in the drinking bowl.
• Illegible or damaged stickers (e.g. type plate) must be replaced immediately with new ones
When carrying out cleaning and maintenance work, note the following instructions:
• Check the status of the drinking system at regular intervals. Damaged equipment or supply lines must not be used.
• Disconnect the drinking system from the electricity supply during periods when frost is unlikely (e.g. in summer).
• Keep the device free from dust and soiling.
• Only clean the device with a soft cloth or damp towel. The cloth or towel should be free of petrol and/or other sol-
vents, since these can attack or damage the plastic.
29
regulating screw

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

222062222063222064222065

Table des Matières