Marantz professional PMD-750T Guide D'utilisation page 7

Example 2 – Stereo Operation
To send a stereo signal from 2 transmitters to the receiver:
1. Connect your microphones to the mic inputs on the transmitters, and connect the
receiver's audio output to your camera's external mic input. Keep the volume
controls on the camera at its minimum settings.
2. If necessary, adjust the RF dB level on the transmitter to get a strong signal for
better operating range and noise resistance.
3. Turn on your camera, adjust the RX output level on the receiver, and the input
level of the camera's external mic input to hear the audio signal (or view the level
on the input level of the camera).
4. In the audio recording settings on your camera, make sure it is set to Manual
rather than Auto. Check the input level meter, and adjust the level so that the
loudest sounds peak around -12 dB. Make sure the sound does not exceed 0 dB,
which will cause the signal to distort.
5. Set the receiver's Output menu to Stereo and adjust the output level to get a
strong signal without clipping.
Transmitter
Receiver
Camera Mic Input
Transmitter
7