Publicité
Les langues disponibles
Les langues disponibles
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
FCC RF Radiation Exposure Statement:
For Canadian models:
• This device complies with Industry Canada licence-exempt RSSs. Operation is
subject to the following two conditions: (1) this device may not cause interference,
and (2) this device must accept any interference, including interference that may
cause undesired operation of the device.
• Under Industry Canada regulations, this radio transmitter may only operate using an
antenna of a type and maximum (or lesser) gain approved for the transmitter by
Industry Canada. To reduce potential radio interference to other users, the antenna
type and its gain should be so chosen that the equivalent isotropically radiated
power (e.i.r.p.) is not more than that necessary for successful communication.
• This radio transmitter (identify the device by certification number, or model number
if Category II) has been approved by Industry Canada to operate with the antenna
types listed below with the maximum permissible gain and required antenna
impedance for each antenna type indicated. Antenna types not included in this list,
having a gain greater than the maximum gain indicated for that type, are strictly
prohibited for use with this device.
• This unit does not exceed the Class B limits for radio noise emission from digital
apparatus set out in the radio interference regulations of the Canadian Department
of Communications.
ESD/EFT Warning: This unit may contain a microcomputer for signal
processing and control functions. In very rare situations, severe interference,
noise from an external source, or static electricity may cause it to lock up. In
the unlikely event that this should happen, turn off the unit, wait at least five
seconds, and then turn it back on again. The pins of connectors identified with
this ESD warning symbol should not be touched.
For best audio quality, avoid using this device in a high RF-radiated environment. In an
environment with radio frequency interference, the unit may malfunction and resume
normal operation after removal of the interference.
For 240-volt use in U.K., use NEMA
plug for local outlet.
Double-Insulated: When servicing use only identical replacement parts.
®
-style 240-volt plug. For other countries use proper
13
Publicité
Chapitres
