Switching On/Off; Changing Blades - HAIRCUT shark TH11 Guide De L'utilisateur

2 Description
(see figure 1)
Ref. Designation
A. Blades
B. On/Off button
C. Electrical lead
D. Bottle of lubricating oil
E. Cleaning brush
F. Cutter cover
G-J. 3, 6, 9 and 12 mm comb attachments
3 Use

3.1 Switching on/off

 When first used, lubricate the blades by applying a drop of oil to the points
shown (Fig. 3).
 Insert the electrical lead into the mains power socket.
 Switch the clippers on by pressing the On/Off button.
 After use, stop the clippers and disconnect the electrical lead.
3.2 Using the comb attachments
 The clippers must be switched off. Select the comb attachment: 3, 6, 9 or
12 mm (Fig. 1, ref. -I).
 Positioning the comb attachment (Fig. 4): grasp the comb attachment by its
sides and slide it into the slots. When the comb attachment is correctly fixed, it
is immobilized.
 Removing the comb attachment: grasp it by the sides and pull it backwards.

3.3 Changing blades

Other blades are proposed as an option, contact your dealer.
 Use a cross-point screwdriver to remove the two screws holding the blades in
place (fig. 5a). Remove the blades (Fig. 5b).
 Install the new blades in such a way that the slots of the blade are positioned
on the retaining studs.
 Insert the 2 screws and tighten them (Fig. 5c). The blades are positioned
automatically.
17
EN