EUROM NARVIK Manuel D'utilisation page 22

Operating

Check that the details on the data plate correspond to those of the electrical
supply which you wish to use for the fireplace. To avoid fuses being blown, do
not use any other equipment on the same socket or electrical group as the one
used for the fireplace.

Install two AAA batteries in the remote control.

Check whether the main ON/OFF switch on the right side of the fireplace is 'off'
(the side with the circle is depressed).

Now insert the plug into the socket.

Switch the fireplace on with the main ON/OFF switch (depress the side with the
stripe). The device is now on standby. You can now further operate the fireplace
with the remote control or with the buttons on the fireplace itself.
Operating with the buttons:

Pressing the O/I button switches the atmospheric lighting on. The red light above
the button will be illuminated. Pressing this button again will switch the
atmospheric lighting off. If you press the O/I button for longer than three seconds,
the dimmer function will start to work: the brightness of the light will gradually
increase and then decrease. Release the button when the lighting reaches the
desired intensity.

Pressing the '1000W' button sets the heating at half capacity (1000 Watt). The
red light above the button will be illuminated and the ventilator will start to
distribute warm air via the upper grille. Don't forget! This function only works if the
atmospheric screen is working! Pressing this button again will switch the heating
off but the atmospheric lighting will continue to work.

Pressing the '2000W' button sets the heating at full capacity (2000 Watt). The red
light next above the button will be illuminated and the ventilator will start to
distribute warm air via the upper grille. Don't forget! This function only works if the
atmospheric screen is working! Pressing this button again will switch the heating
off but the atmospheric lighting will continue to work.

Every time you press a button you will hear a 'beep' and this indicates that the
fireplace has 'picked up' the command.
Operating using the remote control:
It takes a little time before the receiver responds to a signal transmitted from the
remote control. Do not press a button more frequently than once per two seconds as
this will disrupt the function.

You switch the atmospheric lighting on and off using the red ON/OFF button on
the remote control.

The black buttons '1000W' and '2000W' have the same function as the '1000W'
and '2000W' buttons on the fireplace (see above).

Pressing and holding the black 'dimmer' button increases and decreases the
brightness of the light. Release the button when the lighting reaches the desired
intensity.

Every time you press a button you will hear a 'beep' and this indicates that the
fireplace has 'picked up' the command.

When you switch a particular function on using the remote control, the red light
above the corresponding button on the fireplace will be illuminated.
Warning! This heater is not equipped with a device to control the room temperature.
Do not use this heater in small rooms when they are occupied by persons not
capable of leaving the room on their own, unless constant supervision is provided.
22