Buttons On The Control Panel - Proficook PC-UM 1127 Mode D'emploi

Protective Features
The appliance is equipped with safety switches. The appli-
ance can only be operated if the following is observed:
• The mixing container is evenly mounted on the base and
• the lid sits snug on the handle of the mixing container.
Electric Connection
• Insert the cold-appliance plug into the mains socket of the
appliance.
• Before inserting the power plug into the outlet, check
that the mains voltage to be used matches that of the
appliance. You can find the required information on the
nameplate.
• Connect the appliance only to a correctly installed safety
socket. The display and the buttons light up shortly and
you can hear a signal tone. The ON / OFF button flashes.
Standby Mode (With Mounted Mixing Container Only)
• The appliance automatically switches into standby mode
if no button is pressed for approx. 3 minutes. The display
goes out. The ON / OFF button flashes.
• Set the appliance into standby mode early by pressing the
ON / OFF button.
NOTE:
• The appliance will turn off if you remove the lid.
• The appliance automatically switches into standby
mode if you mount the mixing container again.
Short-Interval Use
The appliance is suitable for short-interval use of a maximum
of 5 minutes. Allow it to cool for 5 - 10 minutes before using
it again!
NOTE:
The housing may get hot during operation.
Buttons on the Control Panel
NOTE:
If you select a button it starts flashing.
ON / OFF Button
The ON / OFF button turns the appliance on and off. The
program stops if you press the ON / OFF button while the
blender is already operating. The settings will be lost.
START / STOP Button
Start and stop the program by pressing the START / STOP
button.
PC-UM1127_IM
SPEED / SPEED Buttons
Using the SPEED / SPEED buttons will increase or
decrease the speed setting between 1 and 8. The speed
setting is indicated on the display and the time is preset to
3 minutes.
TIME / TIME Buttons
Using the TIME / TIME buttons will increase or decrease
the operating time by steps of 10 seconds. The maximum
setting is 5 minutes. The duration will be shown on the
display.
PULSE Button (Pulse Operation)
The motor runs in highest speed if you press and hold the
PULSE button. A countdown of 3 minutes is running for
your convenience. The operation stops when the button is
released. The time will stop.
Auto Functions
NOTE:
Within auto functions all speeds and durations are preset.
They will be shown on the display during operation.
ICE CRUSH Button (Ice Crushing)
The blades in the mixing vessel are also suitable for crushing
ice cubes. Press the button ICE CRUSH for this. Fill the ice
cubes until the 1 liter mark only!
NOTE:
You can accelerate the process ...
• by filling water into the mixing vessel in advance.
• by adding the ice cubes through the filling opening onto
the rotating knife.
SMOOTHIE Button (Smoothie)
Press the SMOOTHIE button. The SMOOTHIE button is
especially suited to gentle mixing. The program will control
the speed.
SHAKES Button (Mixed Drinks)
This program is particularly suited for shakes.
CHOP Button (Shredding)
Press the CHOP button to shred food.
CLEAN Button (Cleaning)
Press the CLEAN button for pre-cleaning the appliance.
41
27.07.17