Operation; Restore Factory Settings - HomeMatic HM-LC-Sw1-Pl-DN-R5 Mode D'emploi

Operation

Now you can use the „WebUI" user interface to control your device,
configure it, connect it directly to other devices, or use it in central con-
trol unit programs. Please refer to the HomeMatic WebUI Manual for
more details (you can find this in the „Downloads" area of the website
www.homematic.com).
6 Operation
After teaching-in and configuring the device, you can control the switch
actuator e.g. with a connected remote control to switch on and off con-
nected loads (see the following fig.).
Lights off
30
7
The factory settings of the switch actuator can be restored manually. If
you do this, you will lose all your settings.
To restore the factory settings, please proceed as follows:
•
•
•
•
•
•
Lights on

Restore factory settings

Press and hold down the channel button (A) for at least four
seconds until the device LED (B) will slowly start flashing.
Release the button again.
Press and hold down the channel button (A) again for at least 4
seconds until the device LED (B) will quickly start flashing.
Release the button again.
The device LED stops flashing.
The factory settings of the device are now restored.
Restore factory settings
> 4 s
31