emerio FN-114223.3 Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

FN-114223.3
PARTS DESCRIPTION
1. Clamping ring
2. Front guard
3. Blade fastening screw
4. Fan blade
5. Guard fastening screw
6. Rear guard
7. Motor shaft
8. Control panel
9. Upper standing shaft
10. Lower standing shaft
11. Standing base
12. Screws and washers (4 pairs)
13. Remote control
Control panel
a) "
": On/off
b) "
": Speed button
("1": low wind; "2": Medium wind; "3": high wind)
c) "
": Mode
("
": normal; "
d) "
": Timer
e) "
": Swing function
Remote control
This unit has a remote control. O ne piece of CR2025 battery will be provided with the remote control. Before
starting to use the remote control, remove the plastic protection from the battery. If you want to change the
battery, please refer to the instruction behind the remote control. If it is not in use for a long time, please take the
battery out of the remote control. The functions of the remote control buttons are the same as the functions of
the buttons on the control panel.
ASSEMBLING INSTRUCTIONS
Base and Standing Shaft Assembly
1. Attach the lower standing shaft onto the standing base. Use screws and washers to fix the shaft firmly.
2. Insert the upper standing shaft into the lower standing shaft, turning the upper standing shaft clockwise to
tighten the connection of two shafts.
The Whole Assembly
1. Remove the blade fastening screw and guard fastening screw from the motor shaft spindle.
2. Fit the rear guard by positioning with the location pins. Secure the guard onto the motor body with the guard
fastening screw.
"
: natural; "
": sleeping)
- 4 -
EN

Publicité

Table des Matières
loading

Table des Matières