Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Anleitung AWP 1200 E SPK7
4.4 Speed Control (Fig. 2)
Use the speed control to set the desired working
speed.
Press the "+" button to increase the speed.
Press the "-" button to decrease the speed.
Refer to the display (8) for the set speed.
Set speed = Display x 100
5. TECHNICAL DATA
Voltage:
230 V ~ 50Hz
Power rating:
Speed:
1000-3000 min
Polishing / sanding disk diameter:
Connection thread:
LWA sound power level:
LPA sound pressure level:
Vibration aw
Totally insulated
Weight:
6. Cleaning, maintenance and ordering
of spare parts
Always pull out the mains power plug before starting
any cleaning work.
6.1 Cleaning
Keep all safety devices, air vents and the motor
housing free of dirt and dust as far as possible.
Wipe the equipment with a clean cloth or blow it
with compressed air at low pressure.
We recommend that you clean the device
immediately each time you have finished using it.
Clean the equipment regularly with a moist cloth
and some soft soap. Do not use cleaning agents
or solvents; these could attack the plastic parts of
the equipment. Ensure that no water can seep
into the device.
Wash the polishing attachments only by hand and
let them air-dry. Use only a mild soap and a damp
cloth.
6.2 Carbon brushes
In case of excessive sparking, have the carbon
brushes checked only by a qualified electrician.
Important! The carbon brushes should not be rep
laced by anyone but a qualified electrician.
23.03.2006
7:25 Uhr
Seite 7
6.3 Maintenance
There are no parts inside the equipment which
require additional maintenance.
6.4 Ordering replacement parts
Please provide the following information on all orders
for spare parts:
Model/type of machine
Article number of the machine
ID number of the machine
110 0W
Replacement part number of the required spare
-1
part
180 mm
M14
For our latest prices and information please go to
98 dB(A)
www.ISC-GmbH.info
87 dB(A)
6,76 m/s
2
II/
®
2.2 kg
GB
7
Publicité
Table des Matières
