Installation Requirements; Tools And Parts; Location Requirements; Before Installing Your Pedestal - Whirlpool WFP2411GX Instructions D'installation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

INSTALLATION REQUIREMENTS

Tools and Parts

Check that you have the tools and parts necessary
for correct installation.
Tools required:
5/8" (16 mm) open-end
wrench (for bolts) and
11/16" (17 mm) open-end
wrench (for foot locknuts)
Parts supplied:
Remove parts from package. Check that all parts were included.
Metal pedestal
2
Level
Bolts (4)

Location Requirements

If the All-In-One Washer and Dryer with pedestal assembly
is located in a garage, 6" (152 mm) must be added under
the pedestal so that the All-In-One Washer and Dryer is 18"
(460 mm) above the garage floor. A separate riser, able to
support at least 275 lbs. (125 kg), may be required. The entire
pedestal must sit completely on the riser.

Before Installing Your Pedestal

IMPORTANT: If your All-In-One Washer and Dryer is already
installed, it must be uninstalled.
If you need to uninstall your All-In-One Washer and Dryer, see
the Installation Instructions that came with your model for tools
required.
Uninstalling Your All-In-One Washer and Dryer
1. Unplug the power supply cord.
2. Turn off the cold water faucet.
3. Slowly loosen the fill hose at the faucet to relieve the water
pressure. Use a sponge or towel to absorb the released water.
4. Pull the All-In-One Washer and Dryer away from the wall so
the pedestal can be placed in its final location.

Publicité

Table des Matières
loading

Table des Matières