Steering Trim; Power Setting - Funtek IModel FTK-23504 Manuel D'utilisation

TRANSMITTER SWITCH INSTRUCTIONS
As a general rule, each time you modify a parameter via the transmitter, it is strongly recommended to turn off the
receiver and the transmitter and then turn them on again, so that the changes are taken into account.
A. Pairing operation
When pairing for the first time, FIRST switch the car ON. The receiver LED flashes red quickly. Then on the transmitter keep the
BIND button pushed (D) and switch it ON (A). Red LED on the transmitter will quickly flash in red.
When pairing with the car is done, the transmitter LED will become green solid and red solid on the receiver.
B. Steering Trim
When the chassis switch is turned on and the front tires are not straight, use the ST.TRIM to adjust the position.
• When the car oversteers to the left, ST.TRIM should be adjusted clockwise.
• When the car oversteers to the right, ST.TRIM should be adjusted anticlockwise.
C. Power setting
The potentiometer (C) corresponds to the throttle setting : the more the cursor is turned
clockwise, the faster the car will go. Therefore, if the potentiometer is at minimum, the
car will not move. Conversely, if the potentiometer is set to the maximum, the car will be
able to reach its maximum speed.
It is therefore possible to take advantage of the car's power range from 0% to 100%.
Start
100%
- 6 -
1%
Max.