Additional Safety Instructions For Mini Die Grinder - Haussmann Xpert PNT118-C Manuel De L'utilisateur

ADDITIONAL SAFETY INSTRUCTIONS FOR MINI DIE GRINDER

Inspect the air-powered die grinder prior to each use in order to:

a) ensure that the proper power source is being used;
b) verify that the tool is in proper working order.
Do not use a tool that is not in proper working order.

Do not use oxygen or any other combustible or bottled gas to power this tool.

Do not use this tool in the presence of flammable liquids or gases.

Only use accessories that are specifically designed for use with this tool.

Drain the air tank daily. Water in the air line will damage the die grinder.

Clean the air inlet filter weekly.

The pressure in the line should be increased in order to compensate for an

unusually long air hose (longer than 26' [8 m]). The diameter of the hose should
be 3/8" (10 mm) ID.
Keep the hose away from heat, oil, and sharp edges. Check the hose for wear,

and verify that all connections are secure.
WARNING! Always verify that the grinding area is clear of any flammable materials,
liquids, or gases, because the use of this tool creates sparks when grinding a wide
variety of materials!
Verify that the die grinder is switched off before connecting it to the air supply.

Disconnect the die grinder from the air supply before changing attachments, and

before performing any type of servicing.
WARNING! Verify that grinding accessories that are used with this tool are rated at or
above the tool's speed rating (25,000 RPM). Failure to properly match the accessory
to the tool could result in serious personal injury.
Keep air-powered tools clean and lubricated. Daily lubrication is essential in order

to avoid internal corrosion and possible failure.
Using only lightweight coil hoses from the tool to the wall or to the compressor

coupling.
Do not overload the tool. For maximum efficiency, allow the tool to operate at its

optimum speed.
Do not increase the air pressure above the manufacturer's recommended level.

Doing so will cause excessive wear on moving parts, and possible failure.
In the interests of safety and in order to avoid possible damage to the tool and

injury to the operator, verify that the tool has come to a complete stop before
putting it down after use.
Verify that the workpiece is secure in order to free both hands to control the die

grinder.
Verify that accessories, such as discs, are rated/designed for use with this die

grinder. Verify that they are correctly and securely fastened before connecting the
tool to the air supply.
When grinding, always wear an appropriate face mask and/or respiratory

equipment.
Do not direct air from the air hose at the operator or at others.

When the die grinder is not in use, disconnect it from the air supply, and store in a

safe, dry, childproof location.
16
PNT118-C
!
!