Wake Up Timer - Teac SR-L70i Mode D'emploi

Nap Alarm
You can set a Nap Alarm so that a buz zer
sounds after a set amount of time. The buzzer
sounds for 5 minutes.
Press the NAP button repeatedly until the
desired time appears on the display.
The NAP indicator (
display.
30, 60, 90, or 120:
Depending on the selection, the buzzer will
sound after 30, 60, 90, or 120 minutes.
OFF:
The Nap Alarm is OFF.
< If you want to check the time remaining until
the nap alarm buzzes, press the NAP button
once. The remaining time will be displayed
for a few seconds.
< After the Nap Alarm has been set, it will
function even if the unit is put into standby
mode.
Caution:
The buzzer sound is loud, so do not use
headphones when the Nap Alarm is on.
To stop the alarm
When the buzzer sounds after the set time
elapses, press the SNOOZE/DIMMER button
to stop the buzzer for 10 minutes. It will
sounds again after 10 minutes.
To turn the Nap Alarm off completely, press
the NAP button again.
) appears on the

Wake Up Timer

The unit can be programmed to turn on at a
specified time.
The unit turns on when the timer reaches the
ON time. Then, after 120 minutes the unit will
switch to standby. Or the buzzer sounds for 5
minutes.
You can set two different timers separately with
ALARM 1 and ALARM 2.
< Adjust the clock before setting the timer
(page 12).
Setting the Wake Up Timer
(When using the Alarm 1 button)
Press and hold the ALARM 1 button for
1
more than 2 seconds.
The clock and the timer indicator (
appear on the display and blink.
< If no button is pressed for about 8 seconds,
the timer setting mode will be canceled.
At their default settings, Alarm 1 is set for
6:00 AM and Alarm 2 is set for 7:00 AM.
< If you want to restore the unit to the default
f a c to r y s e t t i n gs , p re s s a n d h o l d t h e
SNOOZE/DIMMER button for more than 5
seconds.
)
21