Temperature Setting; Automatic Off - Soehnle VARIO HEAT PILLOW Mode D'emploi

EN
Important
This heat pillow is equipped with an integrated thermostat, which
regulates the temperature automatically and keeps the heat at a
constant level. The temperature of the heat pillow corresponds to
the maximum permissible value of the applicable IEC regulation
regarding user safety. The device generates a mild heat that does
not have any harmful effect.
Place the heat pillow in the cover. Ensure that the power cord
and the thermostat are outside of the cover. Close the zipper.
Before switching the heat pillow on, please ensure that the opera-
ting element is in the "0" position. Then insert the power plug
into the power outlet.

5. Temperature setting

Use the thermostat to set the desired temperature. The heat pil-
low switches on automatically when the thermostat is set to a
temperature, and the operating light will light up. The heat pillow
shuts off and the operating light goes out if the thermostat is set
to "0".
Attention
Please ensure that the heat pillow sits loosely, i.e. some air circu-
lates between the heat pillow and your skin during use.
Accumulation of heat must be prevented. Never use the heat pil-
low without the cover.

6. Automatic off

The electric heat pillow shuts off automatically after 90 minutes
of continuous use. This saves energy and provides additional
safety, because the heat pillow is never used without supervision.
The operating light will continue to be lit. In order to switch the
heat pillow back on, first set the thermostat to "0" and then back
to the desired temperature.
After use please disconnect the power plug from the power out-
let.
17