Marq Gesture Spot 400 Guide D'utilisation page 6

Follow these steps to use a safety cable (not 1 2 3
included) to secure the fixture to a truss. We
recommend using a safety cable with a
diameter of at least 5 mm and a load capacity
of at least 277 lbs. (126 kg).
Linking
When using multiple Gesture Spot 400 fixtures, you can link ("daisy-chain") them so that each each
fixture supplies power and/or sends DMX data to the next one. This helps reduce clutter in your
cabling and save you setup time.
You do not have to link fixtures for both power and DMX control; you can link them for either
purpose independently. For instance, you could link 6 fixtures together for DMX control while linking
only 3 of those same fixtures together for power (powering the other 3 fixtures separately).
Power
Use a standard IEC power cable to connect the Power Out of one fixture to the Power In of another. As
long as the first fixture is connected to a power outlet, any of the linked fixtures can remain off and still
supply power to the next one.
Important: To prevent undue damage to your fuses, we recommend linking no more than 3 fixtures
in the same chain.
Power Gesture Spot 400
Gesture Spot 400 Gesture Spot 400
DMX
Use a standard 3-pin DMX cable to connect the DMX Out of one fixture to the DMX In of another.
Your connected DMX controller will send its data to the fixtures in sequence. All fixtures in this chain
will receive all DMX data.
Gesture Spot 400
DMX Controller Gesture Spot 400
Gesture Spot 400
6