GE GME04GGHWW Manuel D'utilisation Et D'installation page 8

WARNING
Keep flammable materials and vapors, such as gasoline, away from refrigerator. Failure to do so can
result in fire, explosion, or death.
WARNING
Plug into a grounded 3-prong outlet
Do not remove the ground prong
Do not use an adapter
Failure to follow these instructions can result in death, fire, or electrical shock.
• Plug the refrigerator power cord into its own properly grounded wall outlet with a voltage rating matching that on the
refrigerator rating plate.
• Do not use an extension cord.
• Read all safety precautions on pages 2 and 3.
Hinge
cover
Plug buttons
or screws
Plug
button
Spacer
Leveling legs
8
Door Reversal (on some models)
1. Remove the small plug button on the left
side of the door top cap.
2. Remove the 2 plug buttons or screws on
Hinge
the left side on top of the cabinet.
3. Remove the plastic hinge cover by lifting
it up by the front edge.
4. Remove the 2 screws from the top hinge.
5. Lift the door up and off the bottom hinge
(right side).
6. Tilt the refrigerator cabinet back to
remove the left leveling leg.
7. Remove the screws on the bottom hinge
(right side) and remove the leveling leg.
Move the bottom hinge to the left side
and secure it with screws. Re-install the
leveling legs.
Bottom
IMPORTANT: The left leg has a spacer or
hinge
spacer feature that must be moved to the
right side leveling leg when the door swing
is reversed.
8. Screw the right leveling leg, with the
spacer, back in place on the right side.
9. Position the door on the left bottom
hinge. With the magnetic gasket holding
the door in place, secure the top hinge
with screws.
10. Make sure the door is aligned with the
refrigerator cabinet before continuing.
11. Replace the hinge cover on top of the
hinge.
12. Put the plug button in the hole on the
right side of the door cap.
13. Put the 2 plug buttons on the right side
on top of the cabinet