General Specifications - Onkyo DP-S1A Mode D'emploi

> Before Start > Part Names

General Specifications

Display
2.4-inch, 240 320 dot resolution, capacitive touch
screen
Internal memory
16 GB (including system area)
External memory
2 micro SD card slot (maximum 256 GB
Network Section
Wireless LAN: IEEE802.11 a/b/g/n
BLUETOOTH: A2DP, AVRCP, SBC codec
Supported playback formats
FLAC/ALAC/WAV/AIFF/MP3/AAC/MQA (44.1 kHz/48
kHz /88.2 kHz /96 kHz/176.4 kHz/192 kHz (16 bit/24 bit/
32 bit))
DSD/DSF/DSDIFF *DSD Native (2.8 MHz/5.6 MHz (1
bit))
Maximum Effective Output Power (JEITA)
75 mW + 75 mW (Unbalanced, 32 ≠, 1 kHz, 10 % THD)
150 mW + 150 mW (Balanced, 32 ≠, 1 kHz, 10 % THD)
THD+N (Total Harmonic Distortion+Noise)
0.006% or less
Signal to Noise Ratio
115 dB or more
Frequency band
20 Hz - 80,000 Hz
Interfaces and input/output jacks
Headphone jack: 3 , φ 3.5 mm, impedance: 16
-conductor
*
to 300 ≠
Headphone jack (balanced output): 4
*
mm, impedance: 32 to 600 ≠
* Do not connect headphones that have an impedance
outside the rated range as this may result in damage.
> Initial Setup
1 micro USB port (B type, combined charging and data
transfer)
Gain switch
Low/Normal/High
Continuous play time
Times shown are a guide. Playback times depend on
2) settings.
FLAC 24 bit 96 kHz: 15 hours
* With the screen off, Wireless LAN and BLUETOOTH off,
compliant
playing with Music, and using a 3
headphone connection
Mass of main unit
135 g (4.76 oz)
External dimensions (excluding protrusions)
63 mm
2-1/2" 3-11/16"
Specifications and appearance are subject to change
without prior notice.
We will not accept responsibility for damage arising from
the connection of equipment manufactured by other
companies.
, φ 2.5
-conductor
> Playback
*
conductor φ 3.5 mm
-
94 mm 15 mm
9/16" (width/height/depth)
Advanced Setup | Supplementary Information | Others
En 31