Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
EN
3 / USING YOUR APPLIANCE
• DESCRIPTION OF CONTROL PANEL
COMMANDES (Fig.17):
Depending on the model, the unit is equipped with
the following commands:
AUTOMATIC OPERATION WITH SENSOR:
Key A : switches the lights on/off.
Key B : enables/disables "Automatic" function.
When this function is selected, an "A" appears on
the display C, and the speed of the motor increases
or decreases depending on the smoke, odours
and gas present in the kitchen.
:
Display C
- indicates the automatic operation of the sensor (the letter "A" appears);
- indicates the motor speed selected automatically by the sensor; indicates the filter alarm whenever the
central segment is illuminated or flashing.
Key D : decreases motor speed / Reset; decreases motor speed to zero (stopping); in any case
however, after approximately 1 minute, the hood resumes automatic operation at the speed set by the
sensor. Whenever the key is pressed during the display of filter alarms, a RESET occurs, and the counting
of the hours resumes again.
Key E : increases motor speed; in any case however, after approximately 1 minute, the hood resumes
automatic operation at the speed set by the sensor.
Modification of sensor sensitivity: sensor sensitivity can be modified by operating as follows:
- Stop the hood by pressing key B.
- Simultaneously press keys D and E (the sensor's sensitivity index will appear on the display)
- Pressing keys D or E, the sensor's sensitivity will either increase or decrease
(1 : minimum sensitivity / 9: maximum sensitivity).
- whenever the power supply is interrupted, the sensor will resume operation with a sensitivity index of 5.
Warning: in order to avoid damaging the sensor, never use silicone products near the hood!
OPERATION AS TRADITIONAL HOOD:
Key A : switches the lights on/off.
Display C :
- indicates the motor speed selected (from 1 to 4);
- indicates the operation of the Timer when the number is flashing;
- indicates filter alarms whenever the central segment is illuminated or flashing.
Key D : decreases motor speed / Stop / Reset; decreases motor speed to zero (stopping). Whenever the
key is pressing during filter alarm display, a RESET occurs, and the counting of the hours resumes again.
Key E : enables the motor / increases motor speed /TIMER. Pressing this key starts the motor (at the latest
speed set); pressing the key again increases motor speed, while keeping the key pressed down for a
few seconds enables the TIMER, and 5 minutes later the motor will stop (while the number of speed
setting selected will simultaneously begin flashing on the display); the Timer will remain enabled if motor
speed is changed. In order to disable the Timer, press the key again.
Tip
This guide to installation and use is valid for several models. Minor differences in details and
fittings may emerge between your appliance and the descriptions provided.
AUTO
26
/-
/+
OFF
ON
fig. 17
Publicité
Chapitres
Table des Matières
