Metabo HPT M 12V2 Mode D'emploi page 13

When using the router along the interior
plane of the template, the dimensions of the
finished product will be less than the
dimensions of the template by an amount
equal to dimension "A", the difference
between the radius of the template guide
and the radius of the bit. The reverse is true
when using the router along the exterior of
the template.
(3) Straight guide (Fig.14)
Use straight guide for chamfering and
groove cutting along the materials side.
1 Insert the guide bar into the hole in the bar
holder, then lightly tighten the 2 wing bolts
(B) on top of the bar holder.
2 Insert the guide bar into the hole in the base,
then firmly tighten the wing bolts (A)
(standard accessories).
3 Make minute adjustments of the dimensions
between the bit and the guide surface with
the feed screw, then firmly tighten the 2
wing bolts (B) on top of the bar holder and
the wing bolt (C) that secures the straight
guide.
4 As shown in Fig. 15, securely attach the
bottom of the base to processed surface of
the materials. Feed the router while keeping
the guide plane on the surface of the
materials.
(4) Dust guide and dust guide adapter (Fig. 16)
Your router is equipped with a dust guide
and a dust guide adapter.
1 Match the 2 grooves on the base and insert
the 2 dust guide tabs in holes located in the
base side from the top. Tighten the dust
guide with a screw.
The dust guide diverts cutting debris away
from the operator and directs the discharge
in a consistent direction.
2 By fitting the dust guide adapter into the
dust guide cutting debris discharge vent, the
dust extractor can be attached.
4. Adjusting the rotation speed (Model
M12V2 only)
The M12V2 has an electronic control system
that allows stepless rpm changes. As shown
in Fig. 17, dial position "1" is for minimum
speed, and position "6" for maximum
speed.
Template
guide
Screw
Fig. 12
Template
Guide
Fig. 13
Guide bar
Wing
bolt (A)
Straight
guide
Guide plane
Fig. 14
Fig. 15
English
Template guide
adapter
Bit
Template
A
Wing bolt (B)
Feed
screw
Wing bolt (C)
Bar holder
13