Metabo HPT M 12V2 Mode D'emploi page 12

English
CAUTION:
Ensure that the lock lever is tightened after
finely adjusting depth of cut. Failure to do
so will result in damage to the quick
adjustment lever.
2. Stopper block (Fig. 8)
The 2 cut-depth setting screws attached to
the stopper block can be adjusted to
simultaneously set 3 different cutting depth.
Use a wrench to tighten the nuts so that the
cut-depth setting screws do not come loose
at this time.
3. Guiding the router
WARNING:
(1) Template guide adapter
1 Loosen the 2 template guide adapter screws,
so that the template guide adapter can be
moved. (Fig. 9)
2 Insert the centering gauge through the hole
in the template guide adapter and into the
collet chuck. (Fig. 10)
3 Tighten the collet chuck by hand.
4 Tighten the template guide adapter screws,
and pull out the centering gauge.
(2) Template guide
Use the template guide when employing a
template for producing a large quantity of
identically shaped products. (Fig. 11)
As shown in Fig. 12, to install insert template
guide in center hole in template guide
adapter (A) with 2 accessory screws.
If you are using a template guide adapter
(B), it is possible to use template guides
produced by other firms. Attach template
guides made by other firms to the template
guide adapter (B).
A template is a profiling mold made of
plywood or thin lumber. When making a
template, pay particular attention to the
matters described below and illustrated in
Fig. 13.
12
Be sure to switch power
OFF and disconnect the
plug from the receptacle to
avoid serious trouble.
Quick adjustment lever
Fig. 7
Cut depth
setting screw
Fig. 8
Template guide
adapter
Screw
Fig. 9
Template guide
adapter
Fig. 10
Fig. 11
Centering gauge
Collet chuck