Assembly Of Accessories; Product Family - Herth+Buss ELPARTS Notice D'emploi

Operating Instruction
With threaded bolt
version „FIX" and „PLANE FIX"
EN
1. Drill a ø 14 mm hole in the vehicle body or
the socket pipe plate.
2. Connect the power cable.
3. Secure the light with an appropriate
screw nut.
Electrical connection
1. Connect the red cable to the positive ter-
minal and the black cable to the vehicle
body (Fig. 4a).
2. Synchronisation of multiple lights (if
available): Connect multiple lights as
described in section 1. Connect the green
cable of the first light to the yellow cable
of the second light. If necessary, connect
the green cable of the second light to the
yellow cable of the third light. Repeat this
until the last light.
The yellow cable of the first light and
the green cable of the last light must not
be connected to one another. The first
light synchronises all others
matically (Fig. 4b).
3. The „soft light" function (if available):
connects all lights as described in section
1. Connect the blue cable to the negative
cable from the vehicle required for this
function (Fig. 4c).
www.herthundbuss.com
84770004 I -006

Assembly of accessories

Plug (Fig. 5)
1. Remove the rubber plug Ⓝ and unscrew
the socket Ⓞ.
2. Weld on the socket pipe Ⓟ or screw the
socket pipe Ⓠ Ⓡ Ⓢ Ⓣ Ⓤ to the vehicle
body parallel to the road level.
3. Connect the positive line to the socket
and screw it on to the socket pipe again.
WARNING
Indicates a potentially hazardous
situation which, if not avoided, could
result in death or serious injury to the
operator or bystanders.
auto-
Operating Instruction

Product family

Installation instructions for strobe-type beacons
Socket pipe
6 7
Power connection
Red
Black
Green
Accessories
Extensions Plug for Suction pads
cigarette lighter
Other accessories
Suitable rubber seal Gasket
84770004 I -006
EN
Blue
Yellow