Philips Philishave ProStyler 8 Mode D'emploi page 9

1 Remove the comb attachment by pulling it off the appliance
(fig. 5).
Never pull at the flexible top of the comb attachment. Always pull at
the bottom part.
The comb attachment keeps the cutting unit at a certain distance
from your head.This means that, if you use the clipper without the
comb attachment, your hair will be cut off very close to the skin.
Cleaning
Clean the appliance every time you have used it.
Do not use abrasives, scourers or liquids such as alcohol, petrol or
acetone to clean the appliance.
The appliance and the adapter may only be cleaned with the brush
supplied.
1 Make sure the appliance is switched off and disconnected from
the mains before you start cleaning it.
2 Remove the comb attachment (fig. 5).
3 Open the cutting unit by applying pressure to the centre of the
unit (fig. 6).
4 Clean the cutting unit and the inside of the appliance with the
brush supplied (fig. 7).
5 Close the cutting unit by pushing it back onto the appliance until
you hear a click (fig. 8).
The appliance does not need any lubrication.
Replacement
A worn or damaged cutting unit should only be replaced with an
original Philips cutting unit.
1 Open the cutting unit by applying pressure in the centre and then
remove it by pulling it upwards (fig. 9).
ENGLISH
9