PROLUMIA 4000140 Série Mode D'emploi page 4

WARNING
1. Before installation, please read this manual carefully so the assembly of the light will be done correctly. This manual should be properly
preserved for future reference.
2. The installation and the maintenance of this luminaire must be done by a qualified person.
3. To prevent damages to the luminaire, do not connect a non-dimmable driver with a dimmer.
4. Dimmable or non-dimmable lights, please pay attention to the labels.
5. The luminaire is IP40, so it's only suitable for indoor use. A version for use in damp places is also available (IP44).
6. If the external flexible cable or cord of this luminaire is damaged, it has to be replaced by a qualified person, like the manufacturer or his
service agent.
7. The luminaires are not suitable for covering with thermal insulating material.
INSTALLATION
1. Install the clips as shown in the picture.
2. Cut a hole. For the right cut out size refer to the corresponding item number on page 2.
3. Connect the power wire to the connector of the input wires of the driver. Connect the plug of the driver with the plug of the luminaire.
4. Push the clips up and shove the luminaire in the hole in the ceiling.
5. Secure the luminaire tightly. The clips will fasten themselves.
1
2
Cut a hole (see page 2)
4 Mount luminaire in the ceiling
4
3
Connect the wires
5 Clips will fasten themselves
www.prolumia.eu