Tarm 5 Mode D'emploi page 17

Manual: tarm Series
8.2. Operation instructions: Version 2 - FB4 version
The following operation instructions only apply, if the tarm laser has been purchased with
built-in Pangolin FB4.
With built-in Pangolin FB4 interface, the tarm laser can be controlled over LAN (network
cable) or ILDA cable. It is possible either to connect a LAN cable directly from the PC (laptop /
tablet) to the laser, or use a network infrastructure (switch, router).
a. Connect the power cable to the device and then to the mains.
b. In order to provide the control signal to the laser device, connect the built-in FB4 inter-
face with the PC or Laptop through network cable (CAT-5 or higher). The built-in FB4
interface can be controlled directly from a PC (laptop / tablet) over Pangolin Quick Show
or Pangolin Beyond Software.
c. On software startup, the FB4 interface should be automatically detected and it should
show up in the status bar.
d. Connect the interlock adapter to the interlock connector. The show laser doesn't work if
the interlock adapter isn't connected to the device.
In case of problems or for further operation instructions of the Pangolin FB4, please see the
FB4 operation manual. It can be found here: https://www.laserworld.com/fb4-manual
microSD card
/ up to 64GB
For LAN system connec-
tion to PC with Pangolin
software
The FB4 interface also has a microSD card slot for using playback features. Please see the FB4
manual for details on how to use this feature.
page 17 / 54
Full-color OLED display
Knob for menu selection: turn
for selection, press for OK