Magnat BULLDOG 7 Mode D'emploi/Certificat De Garantie page 16

Audio input for channel 2:
A stereo audio source can be connected to channel 2.
There are two cinch (RCA) sockets, two XLR sockets and two 6.3mm jack sockets available here.
SECONDARY IN – PRIMARY OUT:
Two Bulldog 7 speakers can be connected to one another via these sockets.
For further information, please refer to chapter PRIMARY/SECONDARY Operation (page 18).
OPERATING ELEMENTS AND CONNECTIONS ON THE REAR PANEL
The Bulldog 7 active speaker has a mixer with three input channels that can be controlled separately from one another.
Mixer channel 1:
This channel is suitable for mono audio
sources such as a microphone or guitar.
An input socket is available on the rear panel
for this purpose (see page 15).
CLIP LED (overload indicator):
The LED lights up red if the channel is
overloaded. Reduce the volume (VOLUME)
or adjust the tone control (reduce the bass
and treble levels by using the BASS and/or
TREBLE controls).
MIC/GUITAR:
This switch can be used to select the input
sensitivity for a microphone or guitar.
BASS, TREBLE:
These controls can be used to adjust the
bass and treble levels for channel 1 within
a range of +/-8dB
VOLUME:
This controller adjusts the volume of channel 1.
Battery charge indicator
CHARGING LED:
Lights up red when the battery is being charged.
FULL LED:
Lights up green when the battery is fully charged.
BATTERY LEVEL LEDs:
These indicate the battery charge level (100%/66%/33%).
If the red LED (LOW) lights up, it means the battery is almost depleted and
the speaker will switch off soon to prevent a deep discharge of the battery.
16
Mixer channel 2:
This channel is suitable for stereo audio
sources. Various devices including CD players,
tuners and external mixing consoles, or
instruments such as electric pianos and
keyboards can be connected here. There
are several input sockets on the rear panel
for this purpose (see page 15).
CLIP LED (overload indicator):
The LED lights up red if the channel is
overloaded. Reduce the volume (VOLUME)
or adjust the tone control (reduce the bass
and treble levels by using the BASS and/or
TREBLE controls).
LINE/INST:
This switch can be used to select the input
sensitivity for line level audio sources
(e.g. CD player) or electronic instruments
(e.g. keyboard).
BASS, TREBLE:
These controls can be used to adjust the
bass and treble levels for channel 2 within
a range of +/-8dB
VOLUME:
This controller adjusts the volume of channel 2.